.:: OK International Metcal MX500 TATC ::.

access to technology

your contact persons

Austria and Slovenia:
Christian Thonhauser
+43 1 74040 224
+43 664 23 07 935
c.thonhauser(at)att.co.at

Romania and Bulgaria:
Stanco Vucovan
+36 22 505882
+40 733 104567
s.vucovan(at)att.co.at

Czech Rep. and Slovakia:
Ing. Pavel Tomásek
+421 903465339
p.tomasek(at)att.co.at

Hungary:
István Bögyös
+36 22 505882
+36 20 94 95 477
i.bogyos(at)att.co.at

home » accessories» soldering » solder tips » OK International Metcal MX500 TATC

OK International Metcal MX500 TATC

The Ultimate in Versatility

Choose the correct geometry

Metcal TATC tip cartridges are available in the following tip geometries and in two standard temperature ranges (500 Series and 600 Series).

Metcal's unique design means that a wide range of components can be removed by a small range of tips. You can remove 28-pin SOIC's, tantalums, and 0603 chip caps without changing tips. Where it is possible, a beveled edge is provided to improve versatility. When you use this feature, make sure that all leads are contacted during removal. See illustration below.

Choose the proper Series

Each Metcal cartridge is designed to deliver high power in response to loads. For this reason, you can often work with a Metcal cartridge at a temperature lower than with a conventional iron. 500 Series cartridges will work well for most applications.

Tip cartridges can be inserted three ways

Measurement "A" (Span) refers to the minimum and maximum distance between two cartridges when used together in the Talon^® in the three possible configurations.

Part Number	Description	x = 5 for 500 Series x = 6 for 600 Series Denotes a corner bevel for small components. Please note* TATC tip cartridges are for use with the Talon only
TATC-x01	Fine Point Tip .20" (5.08mm)
TATC-x02	Blades Tip .25" (6.35mm)
TATC-x03	Blades Tip .62" (15.75mm)
TATC-x04	Blades Tip .81" (20.57mm)
TATC-x05	TSOP 32 Tip
TATC-x06	Blades Tip 1.1" (27.94mm)
TATC-x08	Angled Viper Tip .05" (1.27mm)